Installing your new tempered glass screen protector screen protector Hopefully, the duct tape will adhere to the screen protector, and you'll be able to pull it up and off. Start in a corner and press the duct tape onto it, rolling away from a corner slowly.Roll a piece of duct tape around two of your fingers with the sticky side out.If you can, slide a credit card into the gap and slowly push it along to lift the screen protector.Once you can get a corner up, pull with your fingers, once again pulling slowly and evenly.Make sure you point the sharp end up toward the screen protector as you do this and not down toward the screen. Try using a toothpick to pry up one of the corners.Pull slowly and evenly otherwise, you'll have a jigsaw puzzle of tempered glass pieces to clean up.
This will help prevent it from falling to pieces before you can get it all the way off. Once it starts coming up, stop pulling from just the corner and move further along the protector as it starts to peel off.Start by trying to lift the screen protector up from each corner.Method 1īefore getting out your toolkit and working on your iPhone or iPad like it's one of Frankenstein's creations, try removing the screen protector with your fingernail. This should slightly heat up and loosen the adhesive on the screen protector. There are a few ways to remove your busted tempered glass screen protector, and the one you use will depend on just how well-attached the protector is to your screen.īefore you start, use a hair dryer on low on your screen for about 15 seconds. Removing your old tempered glass screen protector
#How to remove an icarez screen protector how to#
Here's how to replace yours so that your iPhone or iPad's screen remains soundly protected. Once a tempered glass screen protector has a crack in it, it's exponentially less effective – you should replace it. It's taken the lumps so that your iPhone or iPad's screen didn't have to. If you have a crack in your tempered glass screen protector, then it's done its job.
0 kommentar(er)
